We service both gas and electric furnace systems with manufacturer-trained technicians.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Blair, WI get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Blair, WI carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
We carry manufacturer service manuals for major furnace brands.
No push toward replacement when a repair genuinely solves the problem.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
From the first symptom to the final fix, these are the specific furnace repair services our Blair-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
We use a combustion analyzer and visual borescope inspection, not guesswork. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
A furnace that runs but never blows warm air often traces to a blower motor or limit switch fault. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
Blocked or improperly sloped venting can back-draft combustion gases into the home. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Turned out to be a failed gas valve — they caught it with a proper pressure test, not a guess.
Shut the furnace down immediately for safety and walked me through the options.
Thermocouple was the culprit, replaced and tested before the tech left.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
No-heat calls during freeze warnings are prioritized across Blair, WI.

Our furnace repair crews are positioned throughout Blair, WI to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Blair Service